im trying to get ecu control to pick up a wide band reading, so i have run the wideband output wire with the noise filter it says to use, and taped it into pin c16 ( pm6 ecu, turboedit) but i cant get any a/f reading in ecu control....is c16 the right spot? bad connection? this sux.... any help is greatly appreceated....

 

bump...is pin c16 the right location for 02 sensor wire

 

I am not sure this is supported as of yet.

 

what? datalogging with ecu control on an obd0 ecu? its supported, i just need to know if c16 is the right location for the 02 sensor wire, im 99% sure it is...

 

http://www.mobstyle.com/crx/ecu_pinouts2.asp

Yes, C16 is the O2 wire.

 

I know datalogging is supported I don't think wideband (5v) logging is supported as of yet. A new release of ECU Control is due out soon and I believe it is going to have support for this.

 

is this true 5v wideband datalogging is not supported by the current version of ecu control? i thought if i just ran the wideband linear output wire into pin c16 ( 02 sensor wire) that i could datalog afr's with ecu control? but its not working a/f in ecu control just says 50 all the way rich all the time.....