HELP!!!
#1
HELP!!!
im trying to get ecu control to pick up a wide band reading, so i have run the wideband output wire with the noise filter it says to use, and taped it into pin c16 ( pm6 ecu, turboedit) but i cant get any a/f reading in ecu control....is c16 the right spot? bad connection? this sux.... any help is greatly appreceated....
#5
#6
Re: HELP!!!
Originally Posted by boosted_b16
what? datalogging with ecu control on an obd0 ecu? its supported, i just need to know if c16 is the right location for the 02 sensor wire, im 99% sure it is...
#7
Re: HELP!!!
is this true 5v wideband datalogging is not supported by the current version of ecu control? i thought if i just ran the wideband linear output wire into pin c16 ( 02 sensor wire) that i could datalog afr's with ecu control? but its not working a/f in ecu control just says 50 all the way rich all the time.....
Thread
Thread Starter
Forum
Replies
Last Post