hey guysi plan on turboing my d15b2 merely b/c its a motor i dont care about and if i blow it up owell. i doing the mpfi swap in the dx right now and i got a pm6 ecu. what do i need to do as far as engine management and how does turbo edit work and where do i get the stuff i need to do it ? radio shack parts #'s etc would be helpful. im running a completely stock motor so im going conservative at like 6-7 psi and want a relatively "safe" tune.

 

http://www.-------------/te

I have write-ups there and you can purchase a chipping kit for your ECU as well there

Chris

 

Those pencil thick rods you have in your D15B2 are not going to like that much boost... especially if you have high miles.

 

yea i understand that my motor will end up blowing in lik 6 months. i only want it to last like 6 moths till i get all the parts to finish builing an ls and the stuff i need to install it. i got like 91k on the motor so im hoping thati can get it to last that long if not i can go back to the 300zx i daily drive. im doing it mostly for the experience using turbo edit and boosting stuff.

 

thats what i'm doing but i hope my D16a6 rods can handle boost for at least a year.. my bottom end has ~65k on it! and i wanna experience TE and learn now so when i get a new engine i'll know what i'm doing to some extent :P