I just got my crx running today, the intercooler is not hooked up yet so it dosnt see boost yet. I have a code 19 which I cont remember what it is and it will only rev to 4000 rpm then hits a rev limiter. It will start without pushing in the clutch so could it be as simple as a bypassed clutch saftey switch? I took a real QUICK look under the dash and did not see a safty switch but I didn't see where one could go or any bypassed wires. I ran outa time for today though. Boost for next weekend if I can get my intercooler welded TIA

 

Ok code 19 is for the auto trans soliniod (I am running a ps9) But I dont have a vtec soliniod right now. I should be able to just install a resistor of equal value as a soliniod to turn the light out? Does any one know what ecu pin it is? I still need to check my clutch switch for the 4000 rpm limit.

 

the auto tranny/VTEC pin is A8....not sure about the rest of that...

 

Are you sure it looks like A12 on my diagram I just found finally

 

Ok you were right I checked alldata today at work and it says a8 so what the ---- is with chilton? Do you think a resistor will work as a simulated soliniod or? Does my threoy of my clutch saftey switch make sence? I wont have a chance till sunday to ---- around again. TIA

 

chilton suks..go get theone fomr the dealer...