As the subject says, I want to run my d16z6 obd0, I know some people have converted p28 maps and they were able to run them on a pm6.

any help would be greatly appreaciated.

 

just use pm6 maps and get it tuned...

 

I just want to get something for now, something to move a little bit better.

 

what he said!

 

he! was you! :P

 

Maybe I should point out my logic as to do what I say...

First, both engines that run on either the pm6/p28 are SOHC's...I think either 1.5/1.6L

There is obviously VTEC in the P28 code though.

So throw in the PM6 maps....set your VTEC point high with your controller and tune all you can on the non-vtec lobe of the cam.

Then switch over to your VTEC point ~4400 and tune the VTEC above that. Now everyone knows that you put the VTEC point where the two power curves would cross but Im betting you dont have a Dyno so you would either have to make an educated guess or try to use your butt dyno where to place that point.