for the masters! I need help converting maps from P28 to pm6
As the subject says, I want to run my d16z6 obd0, I know some people have converted p28 maps and they were able to run them on a pm6.
any help would be greatly appreaciated. |
Re:for the masters! I need help converting maps from P28 to pm6
just use pm6 maps and get it tuned...
|
Re:for the masters! I need help converting maps from P28 to pm6
I just want to get something for now, something to move a little bit better.
|
Re:for the masters! I need help converting maps from P28 to pm6
Originally Posted by xenocron
just use pm6 maps and get it tuned...
|
Re:for the masters! I need help converting maps from P28 to pm6
he! was you! :P
|
Re:for the masters! I need help converting maps from P28 to pm6
Maybe I should point out my logic as to do what I say...
First, both engines that run on either the pm6/p28 are SOHC's...I think either 1.5/1.6L There is obviously VTEC in the P28 code though. So throw in the PM6 maps....set your VTEC point high with your controller and tune all you can on the non-vtec lobe of the cam. Then switch over to your VTEC point ~4400 and tune the VTEC above that. Now everyone knows that you put the VTEC point where the two power curves would cross but Im betting you dont have a Dyno so you would either have to make an educated guess or try to use your butt dyno where to place that point. |
All times are GMT -5. The time now is 08:33 PM. |
© 2024 MH Sub I, LLC dba Internet Brands