Im running the hack on a single cam- fully built w/450's and t3 .60a/r. I also have a customcoach front mount. It was running beautifully then all the sudden my car started running like ---- barely made to my job.It turns on but no reading like tps and map , correction . No tach signal. I checked all inputs with a dmm and all came alright. Has anyone ran into this problem before? My next question , I once heard of someone putting a resistor inline with the map sensor and made it work. Just trying to make it home with the car. Above all can anyone burn my a chip so i dont have to use the hack. Thanks in advance.

 

check your wiring

make sure it didnt come unhooked

 

all wiring is intact. Anyone else with some input?

 

did you open up the insulation up top near the vafc to check the input wires with the dmm? I didn't understand what you meant by that. If not, check it. the wire might have gotten pinched or something. As far as wiring in a resistor inline to the map sensor just to get home, try checking the instructions for the "trailerpark afc" to see if the part is listed in there.