Is my vafc fried??
 

Im running the hack on a single cam- fully built w/450's and t3 .60a/r. I also have a customcoach front mount. It was running beautifully then all the sudden my car started running like ---- barely made to my job.It turns on but no reading like tps and map , correction . No tach signal. I checked all inputs with a dmm and all came alright. Has anyone ran into this problem before? My next question , I once heard of someone putting a resistor inline with the map sensor and made it work. Just trying to make it home with the car. Above all can anyone burn my a chip so i dont have to use the hack. Thanks in advance. ;)

Re:Is my vafc fried??
 

check your wiring

make sure it didnt come unhooked

Re:Is my vafc fried??
 

all wiring is intact. Anyone else with some input? :(

Re:Is my vafc fried??
 

did you open up the insulation up top near the vafc to check the input wires with the dmm? I didn't understand what you meant by that. If not, check it. the wire might have gotten pinched or something. As far as wiring in a resistor inline to the map sensor just to get home, try checking the instructions for the "trailerpark afc" to see if the part is listed in there.