zc dizzy wiring??
#1
zc dizzy wiring??
i was wondering if anyone here have use zc dizzy to do and dpfi to mpfi convert that could help me out how to wire a zc dizzy to finish my dpfi, i get spark but it wont start, it turns over then it stop. thank you
#2
Re:zc dizzy wiring??
Oh so this is your problem? well if you have a DX-ZC its pretty easy.. obviously do your basic DPFI-MPFI swap, and the distributor wiring is easy. The DX and ZC uses the same square plug (5wire 6pin connector) Just plug that in, and run the 2 cylinder sensor wires to the Cam Postion/Angle/Cylinder sensor. It sits off the end of the exhaust camshaft. It has a small green plug that you run 2 wires to it. Green/blue and yellow/blue.
#4
Re:zc dizzy wiring??
run the 2 cylinder sensor wires to the Cam Postion/Angle/Cylinder sensor. It sits off the end of the exhaust camshaft. It has a small green plug that you run 2 wires to it. Green/blue and yellow/blue.
_______________________________________
when you said that do u mean run it from the ecu to the dizzy? or isit somthing else at the exhaust camshaft? im a little comfuse on this thing, its pretty hard. and do u mine if its ok if i IM you on aim for any more help to get my car running again? thanks you - RC
_______________________________________
when you said that do u mean run it from the ecu to the dizzy? or isit somthing else at the exhaust camshaft? im a little comfuse on this thing, its pretty hard. and do u mine if its ok if i IM you on aim for any more help to get my car running again? thanks you - RC
Thread
Thread Starter
Forum
Replies
Last Post
NBLKID
Turbo Parts For Sale
6
09-24-2007 03:18 AM
mycrx
Hybrid/Tech
0
07-15-2006 07:43 PM
92hatchattack
Hybrid/Tech
10
08-19-2004 02:15 AM
Sirex
Turbo Parts For Sale
1
05-22-2003 11:39 AM