zc dizzy wiring??
i was wondering if anyone here have use zc dizzy to do and dpfi to mpfi convert that could help me out how to wire a zc dizzy to finish my dpfi, i get spark but it wont start, it turns over then it stop. thank you
|
Re:zc dizzy wiring??
Oh so this is your problem? well if you have a DX-ZC its pretty easy.. obviously do your basic DPFI-MPFI swap, and the distributor wiring is easy. The DX and ZC uses the same square plug (5wire 6pin connector) Just plug that in, and run the 2 cylinder sensor wires to the Cam Postion/Angle/Cylinder sensor. It sits off the end of the exhaust camshaft. It has a small green plug that you run 2 wires to it. Green/blue and yellow/blue.
|
Re:zc dizzy wiring??
i dont have the connectors with it,so im using the dx connectors and i was wondering does the Green with Yellow strip connect to the Seperate White from the DX dizzy? thank for helping
|
Re:zc dizzy wiring??
run the 2 cylinder sensor wires to the Cam Postion/Angle/Cylinder sensor. It sits off the end of the exhaust camshaft. It has a small green plug that you run 2 wires to it. Green/blue and yellow/blue.
_______________________________________ when you said that do u mean run it from the ecu to the dizzy? or isit somthing else at the exhaust camshaft? im a little comfuse on this thing, its pretty hard. and do u mine if its ok if i IM you on aim for any more help to get my car running again? thanks you - RC |
Re:zc dizzy wiring??
rongconcrx, I got your pics you sent me via email. The pictures of the distributor and the connector you are showing me is a OBD1 distributor. That will not work with 0bd0 electronics
|
All times are GMT -5. The time now is 07:19 PM. |
© 2024 MH Sub I, LLC dba Internet Brands