Re:z6 swap in 91 crx dont run NEED HELP!!!!!!!!!!!!!!!
 

and test to see if you have spark.

Re:z6 swap in 91 crx dont run NEED HELP!!!!!!!!!!!!!!!
 

if u are not getting spark at the end of your plugs. Back up and go to your coil. find the signal wire from the ecu that ungrounds the coil to spark the plug. hook up a test light to B+ and when u crank it should flash if this hppens problem is eather coil wires or cap rotor. if you dont get a signal it is eather a sensor or bad ecu or broken wire somwhere back there

Re:z6 swap in 91 crx dont run NEED HELP!!!!!!!!!!!!!!!
 

Put in new plugs and wires. Still no start.

Sprayed starter fluid in the ic piping. No start.

Couldnt check for spark cause I was all by my self and no matter how much my mom complains about my car she wont help out for 5 mins. But what could be causing it if both my dizzys dont work. Ive been running the chipped ecu for the past 6 months so I dont think that theres anything wrong with that. I used the crx engine harness so I didnt not have to change any wiring.

Re:z6 swap in 91 crx dont run NEED HELP!!!!!!!!!!!!!!!
 

We checked for spark yesterday, and yes there is...at least on the #1 plug.

Re:z6 swap in 91 crx dont run NEED HELP!!!!!!!!!!!!!!!
 

I'd check the timing. I know when I did my headgasket the timing wasn't all that far off, and the car wouldn't start

Timing
Fuel
Spark
Compression


That's all the elements you'll need to fire. One of them isn't there.

Re:z6 swap in 91 crx dont run NEED HELP!!!!!!!!!!!!!!!
 

The igntion timing by the dizzy or the by the timing belt?

When I the cam is straight up and I look through the notch on the timing belt cover It lines up perfectly with the one notch thats all by itself. Thats TDC right?

Ive tried adjusting the dizzy back and forth but it still didnt start.

Re:z6 swap in 91 crx dont run NEED HELP!!!!!!!!!!!!!!!
 

did you mark the dizzy when you pulled it?

i sitll think you have your spark plug wire in the wrong spot. you would still have spark, and you could move the dizzy and your timing could be dead on but if your firing order is off..you would be fucked.

take pictures and post...

Re:z6 swap in 91 crx dont run NEED HELP!!!!!!!!!!!!!!!
 

Im about to leave for work but Ill try to get my friend to take a picture since my smartcard reader is messed up. I appreciate all the help. Thanks.

ShoPow

Re:z6 swap in 91 crx dont run NEED HELP!!!!!!!!!!!!!!!
 

take pictures of ones just like posted above...

Re:z6 swap in 91 crx dont run NEED HELP!!!!!!!!!!!!!!!
 

ok..maybe when you pulled the dist you're not linging it all back up properly.

set the motor to #1 TDC compression stroke. then put the dist on and make sure it's aligned to the #1 terminal. bolt everything back down and try starting it.