welding
ok since i discovered this hole on my transmission, i've been shoppin' around and can't find a manual Accord, I thought about get the hole welded. The car runs fine, the tranny shifts great it's just that hole.
|
Re: welding
ya you can have it welded should run around 150 bucks+
|
Re: welding
jb weld to the rescue
|
Re: welding
I have hydro dx/lx accord transmissions
|
Re: welding
yeah, chris has everything, should ask him before you say ya cant find a trans.
|
Re: welding
You need to find someone with a TIG welder and have them weld it up with a Certanuim filler rod
|
Re: welding
Lemme guess, your diff exploded? I found some aluminum and bashed it into the appropriate shape, then jb welded the piss out of it. Its pretty solid.
|
Re: welding
jam a chicken bone in it.
|
Re: welding
I fixed an LS tranny with the same problem. GUy gets a new clutch installed, something explodes inside all the oil leaks out.
I took a look underneath and there was a dime sized hole where the diff is. Opened that bitch up and sure enough the input shaft bearing fell apart and shot out a ball bearing that the diff cought and blasted through the housing. I just cleaned up the surrounding area put some masking tape outside the tranny's hole, and poured in the JB weld. I heated it with a blowdryer, and after a few hours bolted everything back up. and that ---- ran fine with no leaks. |
Re: welding
jb thatn ----. i have personally seen jb weld do things well that it should not do at all. you could weld it, but thats time consuming and hard.
|
All times are GMT -5. The time now is 02:51 PM. |
© 2024 MH Sub I, LLC dba Internet Brands