welding
#1
welding
ok since i discovered this hole on my transmission, i've been shoppin' around and can't find a manual Accord, I thought about get the hole welded. The car runs fine, the tranny shifts great it's just that hole.
#9
Re: welding
I fixed an LS tranny with the same problem. GUy gets a new clutch installed, something explodes inside all the oil leaks out.
I took a look underneath and there was a dime sized hole where the diff is. Opened that bitch up and sure enough the input shaft bearing fell apart and shot out a ball bearing that the diff cought and blasted through the housing.
I just cleaned up the surrounding area put some masking tape outside the tranny's hole, and poured in the JB weld. I heated it with a blowdryer, and after a few hours bolted everything back up. and that ---- ran fine with no leaks.
I took a look underneath and there was a dime sized hole where the diff is. Opened that bitch up and sure enough the input shaft bearing fell apart and shot out a ball bearing that the diff cought and blasted through the housing.
I just cleaned up the surrounding area put some masking tape outside the tranny's hole, and poured in the JB weld. I heated it with a blowdryer, and after a few hours bolted everything back up. and that ---- ran fine with no leaks.