Valve seating question
#1
Valve seating question
I have done this before using the compound, But not sure if I did a great job or not, I was kinda in a rush, but on my built motor I want to make sure I do it the right way, so how long should I work on each valve seating it in properly? o should I just do it till the contact surfaces are shiny? I just want to make sure its done correctly.
Thanks in Advance.
Thanks in Advance.
#2
Re: Valve seating question
if you grind them right they wont be shiny, they will be a dull grey color
i did prob 2-3min each valve, i just made sure they looked uniform all the way around the seat
its kinda hard to mess up, if you are unsure just keep going
i did prob 2-3min each valve, i just made sure they looked uniform all the way around the seat
its kinda hard to mess up, if you are unsure just keep going
#4
Re: Valve seating question
yai bought the compound and used a bench grinder, with the wire wheel?? i took some valves out of my old y7 head, and did them, i guess it turned out right, i mean it looked like the valves had small chips in it?? around the seat, or so, maybe it was from the nitrous that distroyed the motor?
Thread
Thread Starter
Forum
Replies
Last Post
crxrx7
Hybrid/Tech
2
03-15-2004 12:03 AM