I have a set of vitara pistons and tt rods, but the pin doesnt fit the rod at all. not one pin fits one rod. has anyone else had this problem? i ran a search and saw jago had one that needed a slight machining but these just outright dont fit..

 

it says on there website that machining may be required on the small end

 

wow i am an idiot. i really dont know how i missed that.

 

a finger and some 80 grit should be ghetto enough

 

at least use 100-120 grit

 

it appears as though there will be a very thin layer of the brass, if thats even what it is, inside the pin end of the rod, if any is left at all. if it is all removed that seems to me like it wouldnt be good for it seeing as its there to begin with...

 

Not to sound like a total idiot, but are you sure that you have the correct rods?

 

well i am unable to find a marking on it indicating which rod it is, but i ordered teh d series.