you arent going to remove all the brass

 

They fit fine. I ran TT rods/vitaras on the last car and installed another set in my friends ride. Take your time, use a little oil.

 

so i measured the diameters with a caliper. the outside diameter of the pin is 21.1 mm the inside diameter of the hole is 18.9 mm. which leaves a difference of 2.2 mm. and is more than the ammount of brass inside the rod. now this leads me to the question, is the pin incorect or is the rod incorrect? anyone have measurements on hand?

 

if your pins are 21mm, you dont have d series pistons...

b series - 21mm wristpin
d series - 18mm wristpin

unless you by change have GX(i think) slugs

 

the pistons are in fact wrong. tuner toys ftmfw. thanks for the help