88crxSi

LMFAO!

accordepicenter

I personally have never had a tranny stick hardcore unless somthing was left bolted in etc... like the other night i missed a bolt from the engine to the tranny on the back of the block (sorta out of plain sight) and i didnt pick up on it right away

d16z69psi

The starter bolt did the trick!! The bitch fell out all by herself. Thanks guys. appreciate all!

rob42386

LOL i did the same thing a while back, but now the problem is getting the Crank pulley bolt out!!!!

juli0_bustamante

crank pulleys are the enemy..i hate them with a passion.

however, u usually heat the bolt and the go to work with a large breaker bar and a big *** pipe.

make sure the flywheel doesnt move though.

Semnos

I drive around without the 5th rear bolt from egnine to tranny and without the bottom starter bolt .
When I blow my engines I can swap them easy...4 bolts and the tranny comes loose from the engine

rob42386

Well what should i heat it with? i got this like blue tank heat tank thing!! some reason i cnat think of its name!!

Also what would be the best way to hold the flywheel

the tranny is off, do i need to put it back on?

Paperchase013

the best way is with a chain wrench and a breaker bar. most part stores will rent u a tool made to pull honda crank pulley bolts.

J-SMITH69

i take mine to this metal shop that works on tractor trailers. his air gun take it right off

warric_k

first time I had to do that with the engine off, I shoved a piece of metal against the flywheel, somehow keeping it from turning, and then wrenched the crap out of it.

now you can get a pulley tool, makes it much easier. you put it on, use a ratched to hold it in place, and then work on the pulley bolt with a breaker bar.