Swap and build questions
04-18-2006, 10:23 PM
#1
3.0 BAR
Thread Starter
Join Date: Aug 2005
Posts: 1,654
Swap and build questions
Ok i'm probably going to buy a JDM 92-95 sir2 swap this week. How much of a bitch is it going to be to throw that in my 2000 ex? It come with the harness, so what do i need to make it work? How hard will it be to convert to OBD2 when i need to pass emissions? what parts will i need? Anything else in respect to axles, motor mounts or other misc. ----?
Also i'm planning on building it with SRP pistons, and tunertoys rods. The rods say they may support 8000 RPM, and i need to know if i should upgrade the rod bolts. I'm not planning on going over 350hp, but i will be going to 8000+ a lot.
Any help is greatly appreciated.
Also i'm planning on building it with SRP pistons, and tunertoys rods. The rods say they may support 8000 RPM, and i need to know if i should upgrade the rod bolts. I'm not planning on going over 350hp, but i will be going to 8000+ a lot.
Any help is greatly appreciated.
04-20-2006, 10:45 PM
#6
3.0 BAR
Thread Starter
Join Date: Aug 2005
Posts: 1,654
Re: Swap and build questions
Originally Posted by CSaddict
Good luck going back to OBDII. Crank position sensor?
oh well even if isn't i still have 2 years until my next emissions test :P
Thread
Thread Starter
Forum
Replies
Last Post
Gold DA9
General Discussion
1
08-15-2008 11:58 AM
catch.can
General Discussion
87
05-22-2006 11:52 AM
projekteg
Hybrid/Tech
13
01-17-2006 10:14 AM
