Rod bearings not aligning propertly
06-17-2006, 10:13 AM
#1
0.5 BAR
Thread Starter
Join Date: Dec 2003
Posts: 64
Rod bearings not aligning propertly
sup all, I am rebuilding my ls/vtec and I have across this problem (hopefully not).
I am using eagle rods and Topline (kings)bearings.
The bearings dont seem to align propertly with each other as you see on the pictures. Is this gonna cause a problem or are they fine?. I have a set of used ACL bearings and they are a little wider that the Kings and you can barely tell the miss aligment.
I checked to see if they gave me the wrong bearings but the box I have says RBH16 which checks out with being for an LS. Gsr and Type R are RBH18V.
Any suggestions?
Thanks
I am using eagle rods and Topline (kings)bearings.
The bearings dont seem to align propertly with each other as you see on the pictures. Is this gonna cause a problem or are they fine?. I have a set of used ACL bearings and they are a little wider that the Kings and you can barely tell the miss aligment.
I checked to see if they gave me the wrong bearings but the box I have says RBH16 which checks out with being for an LS. Gsr and Type R are RBH18V.
Any suggestions?
Thanks
06-17-2006, 12:21 PM
#3
0.5 BAR
Thread Starter
Join Date: Dec 2003
Posts: 64
Re: Rod bearings not aligning propertly
here are other pics
Eagle rods and ACL bearings
Stock rods and Kings bearings
I have also used Kings bearing for the mains and they were fine. I guess I will have take a loss and get ACLs.
Eagle rods and ACL bearings
Stock rods and Kings bearings
I have also used Kings bearing for the mains and they were fine. I guess I will have take a loss and get ACLs.
Thread
Thread Starter
Forum
Replies
Last Post
LSD Motorsports
Turbo Parts For Sale
17
05-16-2007 07:35 PM
mij_nagrom88
General Discussion
19
11-27-2006 02:44 PM
