even tho i stole this, i thought it could help a lot of us out.

First step is to check continuity. I was just going to use Hondata's site but am I glad I didn't!!! Mine was completely different from what their site said. You will then cut these wires about 1 inch from the distribution block.

Next step is to splice the wires on the injector box itself to prepare for soldering.

Step 3 is too solder extra wire onto the injector box. I had to do this because of where I was mounting it.

Step 4 is to wire all 4 wires of the distribution block together (These wires are the one you tested in step 1) and solder the red wire to them.

Step 5 is to wire the black wires to the 4 yellow and black wires on the harness side. I heat shrank mine when I was done to make it neat again.

Step 6 is to find a place to mount it. I mounted mine on a already tapped 10mm hole right by the clutch master cylinder. Here it is ready to be mounted.



some of you may have seen it already at other sites, i just thought i'd bring it to everyone else.