resistor box install... how to
even tho i stole this, i thought it could help a lot of us out.
First step is to check continuity. I was just going to use Hondata's site but am I glad I didn't!!! Mine was completely different from what their site said. You will then cut these wires about 1 inch from the distribution block. http://www.imagestation.com/picture/...8/fc107111.jpg Next step is to splice the wires on the injector box itself to prepare for soldering. http://www.imagestation.com/picture/...d/fc107027.jpg Step 3 is too solder extra wire onto the injector box. I had to do this because of where I was mounting it. http://www.imagestation.com/picture/...d/fc106fc4.jpg Step 4 is to wire all 4 wires of the distribution block together (These wires are the one you tested in step 1) and solder the red wire to them. http://www.imagestation.com/picture/...0/fc106d35.jpg Step 5 is to wire the black wires to the 4 yellow and black wires on the harness side. I heat shrank mine when I was done to make it neat again. http://www.imagestation.com/picture/...a/fc106fbf.jpg Step 6 is to find a place to mount it. I mounted mine on a already tapped 10mm hole right by the clutch master cylinder. Here it is ready to be mounted. http://www.imagestation.com/picture/...5/fc10701a.jpg some of you may have seen it already at other sites, i just thought i'd bring it to everyone else. |
All times are GMT -5. The time now is 10:28 AM. |
© 2024 MH Sub I, LLC dba Internet Brands