Project built h22a in my crx hf... some pics inside..
#31
I looked through the axle hole's on the hub when the motor was dropped in and it didnt look like it would have much of a bind if any at all. actually I dunno what mounts these are, got them for cheap so I figured what the hell why not try them. OK everyone I have a list of parts I want/need to get my project done.
1.h22a injectors.
2.alt bracket for h22 with d-series alt.
3.cable to hydro bracket.
4.obd1 h22a dizzy.
let me know how much for them shipped if you have any. I also have h22a into eg mounts for sale along with some b18 into 88-91 civic mounts. 75bucks each set.
1.h22a injectors.
2.alt bracket for h22 with d-series alt.
3.cable to hydro bracket.
4.obd1 h22a dizzy.
let me know how much for them shipped if you have any. I also have h22a into eg mounts for sale along with some b18 into 88-91 civic mounts. 75bucks each set.
#32
UPDATE: I went ahead and ordered some h22a injectors instead of looking for them anymore lol. I got the timing belt on the fpr in place under the hood, fuel lines ready and all with the block and head cleaned then painted with a nice silver paint. excuse the wires I had the harness sitting there so I can extend my alt wires.
but here is another pic of it now..
but here is another pic of it now..
#34
I know I "COULD" have but I bent the fin on the inside of it trying to take the pulley off. but its cool Im going with d-series cause they are dime a dozen and easy to find. I got my wiring done for the alt and other wires hooked up aswell. so its almost ready to start. waiting on my injectors and I have to drive almost 3 hrs to pick up my ecu's.
#35
UPDATE: got the obd1 jumper harness in and made my own little harness for vtec solenoid,vtec pressure switch,knock sensor and a couple grounds. turned out pretty good. used plugs off an integra harness to make it. what radiator hoses can I use for this setup
#36
Another update: Spaced the hood for motor clearance and drilled holes for hood pins. Im not gonna make the same mistake I did last time (the hood came up on me @ 120 mph when I was walking a mustang gt on the highway). my last was a b18b1 crx hf obd1. I cant wait to see what she pulls like now
#40
UPDATE: Made my own cable to hydro conversion. works well but this clutch is supposed to be stage 5 for track so its a lil hard to push in. And dont mind the weld on the rod the welder was acting up and the wire would not feed right. it would only for a sec then stop then go out of the blue again so it was hard to weld it.
This pic was with the clutch pushed in.
This pic was with the clutch pushed in.