piston rings postion???
#1
piston rings postion???
i was wondering if there was a specific way the rings had to sit when putting in pistons into the block. any pics out there with directions? would it matter how the rings sat on the pistons? anything would help... thanks
#3
Re: piston rings postion???
Originally Posted by andyvaj
i was wondering if there was a specific way the rings had to sit when putting in pistons into the block. any pics out there with directions? would it matter how the rings sat on the pistons? anything would help... thanks
Basically the ring ends must be staggered. You also are not supposed to position the end gap inline with the piston pin (3'oclock or 9 o'clock) or the 12 o'clock or 6 o'clock positions. Reason being that you dont want all of the ring ends along the same position.
Thread
Thread Starter
Forum
Replies
Last Post