so i ran to autozone to pick up some gaskets and i came back and my dumb *** friend tourqed the head studs to ------- 80ft lbs so how fucked am i ?

 

run it

 

well after i flipped the ---- out on him i went in and came back out and he lossend the bolts lmfao i guess he thought i wouldnt be as pissed or something

so could i just go buy some new head bolts and head gasket and it be ok or do i need to take the head back in to the shop to see if its worped ?

 

dude your not warping a head with headbolts



it would require overheating the motor


running uber boost to the point that your temp is has red has hotrex's *** after an ---- gangbang


---- intercoollllerr's dawggggggg

 

Lol i would not have loosened them off again but whatever just giver

 

so how fucked am i ?

 

the car is prolly fine if you didint hear any pops but i guess well find out when the motor heats up expands and your head cracks and ther's a i blew my motor thread wont we!!!!!!!!! over all just run it see what happens

 

its fare from running !!!! lots of wiring to do and the obd0-obd1 swap so this is why im asking if i should go buy some new head studs and a head gasket what would this have hurt ? or even might of hurt .. i don"t want to ---- this up and have to pull everything back off and do it again

 

you %68 fucked probly

 

I dont see why you would need a new head gasket. If it were me I would just re-torque the bolts to spec and call it a day, if you think they are streched at all just get new bolts and be done.

I highly doubt it would hurt anything unless they were torque'd to the point where you stripped threads out of the block. worst case scenario a bolt is streched but I dont know if you can even strech a bolt without running the motor.