what other oem intake manifold would fit the z6 without mods to actually put it on and would actually make power....?

 

Get it ported by Chris the mod, at the same time get one of his tb.

 

For people wanting miracles with adding a manifold alone its not going to happen. A large reason why aftermarket manifold make more power is larger inlet sizes


Now if you slap a 55mm throttle body yes plate size of a d16z6 onto lets say a edelbrock unit which is a great item your gains will proably be well no gains


The throttle body is half the battle and is needed with manifold changes hands down. Why have a bad *** manifold with a poor performing small stock oem tb.


Simple answer you want power gains from manifold changes


-oem ported unit, not 30 minutes with a dremel


or



edelbrock is the only sohc unit out there worth a damn. I have already proven my spacer plate/ported z6 manifold/throtte body set up to own the skunk2 throttle body/manifold set up for the sohc

 

so where does that put the y8 oem manifold? i thought that was they highest flowing stock manifold?

 

junk

 

GE unit is really nice too.

GSR TB + GE intake = 400whp D that has a flat torque curve to 8400rpm.

 

the only reason why I ask is bcuz am running a a6 int. mani. and my tb broke yesterday...

can I run a z6 mani on my crx obd0

 

Why not get a different tb?

But yes it should bolt up, all D's had the same head bolt patterns I thought.

 

what other tb would fit my a6 intake mani....?