OBX LSD bearings ?'s
#22
Re: OBX LSD bearings ?'s
Got my trans together and with the bearings on, Used a mallot and used the Balance shaft pulley to use as a spacer to mallot them on. HEPLFUL TIP FOR THE H AND F GUYS. Got the LSD in and the trans together with a .65 shim tolerance. HT played helpful " sorry NEegrooos" but it any who, it's together and when I put into neutral and spin the shaft its clean no knocking or resistance. SHWEEEW........ Bone thanks again and the -----BOR FREIGHT would not take a return "ON SALE" bolting the trans to the block tomorrow and going to wait till next week for the snow to melt to do several 180's and then drain and put a 30/70 blend of lucas/HONDA ATF fluid in it. AND BDVT I got the RP fluids on stas by after the motor is in and the whole set-up is reasy to fire up
JUST TO LET YOU -----S KNOW
WE are in a BLIZZARD EFFECT WARNING in INDIANA got a meeer 7 inches. weather forecasters are so wrong on the Boob tube. Snow drifts are a MO FO. has to drive the 9mpg Bronco
JUST TO LET YOU -----S KNOW
WE are in a BLIZZARD EFFECT WARNING in INDIANA got a meeer 7 inches. weather forecasters are so wrong on the Boob tube. Snow drifts are a MO FO. has to drive the 9mpg Bronco
#24
Re: OBX LSD bearings ?'s
Originally Posted by widebody93
bolting the trans to the block tomorrow and going to wait till next week for the snow to melt to do several 180's and then drain and put a 30/70 blend of lucas/HONDA ATF fluid in it. AND BDVT I got the RP fluids on stas by after the motor is in and the whole set-up is reasy to fire up
Thread
Thread Starter
Forum
Replies
Last Post
LSD Motorsports
Turbo Parts For Sale
17
05-16-2007 07:35 PM