Does anyone know how much notching is needed on a d16z6 for tunertoy rods , or would i have to take crank, girdle, rods pistons etc, to the machine shop. If theres a certain amount to where i could jus inform my machinest instead of feeding him all these parts, id like to know. Thanx in advance.

 

---- I wanna know too.

 

Die grinder untill they fit

 

is there a balance on where the notching is required or , can i set a grind stone to it and just figure from there.

 

Haha a grind stone will fall apart way before you make a dent in a sleeve. You need a carbide burr. They're like $20 at Ace hardware and the things are indestructible. I got a Foley brand I think it was (it came in a red pouch), and with that bitch I did 8 notches in a few minutes.

 

cool thanx. i found a write up on it.

 

post it *****!

 

Sticky Maybe!
http://www.theoldone.com/articles/d%...ilding%5Ftips/

 

+1

 

if you're gonna bore and hone it, should you notch before or after the machine work?