Notch for TunerToy Clearance .
Does anyone know how much notching is needed on a d16z6 for tunertoy rods , or would i have to take crank, girdle, rods pistons etc, to the machine shop. If theres a certain amount to where i could jus inform my machinest instead of feeding him all these parts, id like to know. Thanx in advance.
|
Re: Notch for TunerToy Clearance .
---- I wanna know too.
|
Re: Notch for TunerToy Clearance .
Die grinder untill they fit :6
|
Re: Notch for TunerToy Clearance .
is there a balance on where the notching is required or , can i set a grind stone to it and just figure from there.
|
Re: Notch for TunerToy Clearance .
Haha a grind stone will fall apart way before you make a dent in a sleeve. You need a carbide burr. They're like $20 at Ace hardware and the things are indestructible. I got a Foley brand I think it was (it came in a red pouch), and with that bitch I did 8 notches in a few minutes.
|
Re: Notch for TunerToy Clearance .
cool thanx. i found a write up on it.
|
Re: Notch for TunerToy Clearance .
post it nigga!
|
Re: Notch for TunerToy Clearance .
Sticky Maybe!
http://www.theoldone.com/articles/d%...ilding%5Ftips/ |
Re: Notch for TunerToy Clearance .
|
Re: Notch for TunerToy Clearance .
if you're gonna bore and hone it, should you notch before or after the machine work? ???
|
All times are GMT -5. The time now is 03:21 AM. |
© 2024 MH Sub I, LLC dba Internet Brands