benjamin

hey guys i have a 94 LS with a obd2 96 b18c-r swap. I think I have everything hooked up right and when i turn the key the engine turns over but it does not fire. I checked for spark and there is no spark. I read about people cheacking the coil for spark but i am unsure of how to do so. any help or other suggestions would be appreciated.

Thanks in advance

87na_rx7

when i get no spark i usually start with the cheapest thing then move to the expensive ----, so start with a new cap and rotor, then a coil, then ignitor, then dizzy.

beerbongskickass

A coil and ignitor for a d16z6 at NAPA is $177...

88crxSi

the cheapest thing is free, check your wiring.

what ecu are you using? any check engine lights? what engine wire harness are u using?

benjamin

i am using the obd2 p73 they sent me with the engine, im using the original harness from the car connected to the harness that came attached to my engine and, when i jump the ecu to check for cel codes it is just a constant light, no flashing looks the same as when i turn the key to on when it is not jumped.

B16Drag

you're car is an OBD1 but you are using an OBD2 ecu?

Did you by chance convert it from OBD1->OBD2?

I would seriously double check all your wiring and connections especially to the distributor and the ECU.

benjamin

my car is obd1 and the engine is obd2, i am using a obd conversion harness that i purchased from evasive motorsports.

I am going to double check my wiring right now