How do I get the extension rod off??
I see I can take out the spring pin, but I tried ones, but how do take it out? hit it with sumthing?? from top or from the bottom.
Is there another way to take the Rod out?
Thanks for any help...
my tranny bearings are dead and the oil seals are leaking...got me another tranny from a Esi (D16Z6)

 

you take out the screw,, then stick a screwdiver in the hole and push it along to get it started, then wiggle it as you pull and it should lide out

 

pull one of the long bolts out of your A/C compressor ( the ones that hold the compressor on the mount) and use the end of that, it fits perfect :P

 

I have no AC compressor
There isn't any screws....its has a clip when you remove the clip you see like a pin in a hole it is a pin with ahole in it itself and it's split with a zigzag split in it.
I hammer it and nothing

 

are you talking about the pin for the shift linkage? if so, you have to use a ummmmmm, ----, i forgot the name, oh yeah, a punch, or pin punch, or punch pin or something. you also have to get a new pin, i forget what they're called, but they usually have them over the counter at parts stores in a box with various sizes of them.

 

Well I got mine off....used a big hammer and some screw drivers ....banged it real good.
I reused the pin...it looked ok.
Couldn't get a pin here....they said to go to the Honda Dealer.....well I don't have time for that and I'm on foot or bike.
Anyways...I got my new tranny in.
Don't ask what happened to the old tranny

 

what happened to the old tranny?

 

hahaha lol
Well i overtorqued a pressure plate bolt....and it it broke on the highway....it made some grooves on the pressure plate plating, just superficial damage.
But it made a hole in the tranny(inside) and the oil was leaking inside the tranny where the clutch is at.