v.1 told me i have no clue about porting.
http://www.flickr.com/photos/2227047...74162111/show/

this is v.2.
http://www.flickr.com/photos/2227047...75705990/show/


i took some advice and it turned out batter i think. i only did the #1 cylinder on the intake side to see if im doing it right and not waist my time doing everything.



again, i'd like to see what you guys think. what could i do to make it better and etc. thanks.

 

before it goes back on get a good valve job and have them unshrouded too.

 

You need to do more reading on head poring.

 

yeah, thats a must. a few were leaking before i started anything.

thanks.

this is just for practice, idc if i ---- anything up. you have any useful info ?

 

----, anyone else ?


i <3 you chris. :P

 

It dosent look like you ported much. U can still see the casting marks in the head. I just did a b16 head and all i did was port match too the gaskets and smooth the lip around the valve seats.