my car don't run right help
#1
my car don't run right help
I just put a d16z6 motor in my 88 si. the motor has all new pumps, rings, gaskets. i have a rhb5 turbo setup on it as well. i just got everything in and i turned it on. it will crank up and you can rev it up but it won't idle, once you let off the gas it cuts off. also i don't see any boost on my gauge, all im getting is 20vac when i rev it up. the exhaust isn't hooked up i just got the o2 housing on it so i can't really hear if anythings wrong. also im not getting any oil pressure. im pretty sure the pump is working because i primed it and i took the oil filter off afterwards and it had oil in it. the car only ran for 20 seconds at a time so i think it would take a lil' while for the pressure to build up in the gauge because of the turbo oil feed line soaking up all the oil supply. i set my zdyne to one of the 1bar pm6 tunes with vtec control and i set it for 450 injectors and to run them 3-4% lean. i can't think of what's wrong. if you have any suggestions please let me know. i wanna drive my car!
#3
Re:my car don't run right help
my tachometer doesn't work......i think when i put the dash back in i forgot to plug something up so i don't know how high i revved it, aprox. 2-2.5k im guessing. but when you let off the throttle it drops down to idle and cuts off. how do you suggest i adjust the idle? should i just change it to 1k with the zdyne? or adjust it on the throttle body.
Thread
Thread Starter
Forum
Replies
Last Post
Tough-guy
General Discussion
21
01-25-2007 12:32 AM
TurboEF9
Engine Management
9
06-03-2005 11:58 AM
SlowRider
Forced Induction
26
11-06-2004 09:38 AM