Today i hooked all the shift linkage stuff up cause i have to put it in the garage becuase of the gay code enforcement. I tried to push it and the thing wont roll the front tires will not spin when its in neutral?? Its a b18a1 with integra axles. Anybody have any ideas??

Phil

 

Try disconnecting the shift linkage and manualy putting the tranny into neutral. Also make sure nothing is hanging up in the lnkages. Maybe thats why it's not shifting.

 

I njust got out from under the car. I unhooked the axles from the hubs and the axles spin but not while there in the hubs? makes no sense

 

maybe if you remove the dust shields from the hubs, ive heard of that happening, but ive got the exact same swap and its not a problem

 

maybe you're too weak ? haha jk.

have you any exp w/ this tranny actually working? I say jack her up and see if the tires spin freely.

 

There are rubber inserts inside the inner hub that you have to pry out with a flat head and then re-install the axels! They will work just fine then! It is because they are a little differn't that the civic axels at the end where the plug into the hub!

 

I agree with mattssi, pull the axles out of the hub and pry out those seals. I had to do this when doing a B18C1 into a friends Rex. It does not look very thick, but it is enough to bind up the axles. Good luck.

peace
Griff