Re:modified b16 startup issues
 

wait, I thought you said you were using a PM6?

Re:modified b16 startup issues
 

i am using a pm6, its chipped for turbo edit with the pr3 stock rom... recurved for 450 injectors the car will idle for a second then shut off. and it doesn't like to rev much...

Re:modified b16 startup issues
 

is this alis old crx? the ebp one? hahah u still havent got that thing goin? btw the zdyne was perfectly fine....

Re:modified b16 startup issues
 

try using the pr4 map and see what that does. also, since you don't have your down pipe on the header, is your o2 sensor not getting a reading, or is it in the stock location near the top of the header?

Re:modified b16 startup issues
 

for your info, there is something wrong with the zdyne, when i sent it to zdyne the first time they had to fix a few things on the ecu and it still does not work and hasn't from the start. The people at zdyne don't know what is wrong with the ecu either.

Re:modified b16 startup issues
 

projekteg, i will try out a pr4 basemap... and let you know the results. the o2 is located on the lower section of the 2-peice header and is wired. I have to check if it is recieving current.

Re:modified b16 startup issues
 

pr4 basemap was a no go. The pr3 acted better

Re:modified b16 startup issues
 

fawk it!!!! i give up. :'(

Re:modified b16 startup issues
 

for one, the rom is prolly too lean. on startup, the injectors are dumping more fuel than @ idle. so scale it up 5% at first across the board.

secondly, check and see if the launch control is activated @ 4000 rpm on the basemap (it will disengage @ 8mph) i think that it is, so edit it and make it like 6000rpm, or disengage it completly

hope this helps
mike