Re: mixing heads with blocks
 

Good call.

Re: mixing heads with blocks
 

so is there a way to move the oil stick
or is there another oil pump i can use on a y5 block thats good
all i hear is Y pumps are crap and why?
what if i was to use a d16a6 block would that be better then y5 block?

Re: mixing heads with blocks
 

I fucked a y8 oil pump last night

Re: mixing heads with blocks
 

Did you end up stripping out the block? :P GSR head bolts on any ls/vtec combo...no matter if you have a b16 head, gsr head, or type-r. And why downgrade from a b-series to a d? :-X

Re: mixing heads with blocks
 

wrong, use all 88-95 bolts, when putting a Y head on an 88-95 block use 9 88-95 bolts and 1 Y bolt.

Re: mixing heads with blocks
 

i had to sell the motor for a new car my car was totled and the motor was fine.
as for the gsr head studs there were fine they worked perfect.

88-95 block use 9 88-95 bolts and 1 Y bolt.
where does the one Y bolt go?

Re: mixing heads with blocks
 

my d series head stud knowledge is right

Re: mixing heads with blocks
 

there are oilpump mods for the obd2 oilpump.
the reason it sucks is because it doesnt flow as much as the obd1 or z6 oilpump.
but here are the mods.
http://www.theoldone.com/articles/d_...mp%201%20A.jpg
http://www.theoldone.com/articles/d_...mp%202%20A.jpg
and opening the holes in the bearings.
http://www.theoldone.com/articles/d_...tting%201A.jpg
http://www.theoldone.com/articles/d_...building_tips/

Re: mixing heads with blocks
 

drunkinmaster1 thx for the oil pump page it helps alot.
last where does the one heas stud go the odd one?
thx for all the help all.

Re: mixing heads with blocks
 

umm, no its not. well, i guess it might be, but what you wrote is wrong.