ls rods in d16 block
#4
Re:ls rods in d16 block
you have to use aftermarket pistons with it so if you're going to go low budget, vitraras + ls rods aren't that bad of an idea.
You can do the block "machining" with a dremel or air grinder. Same as any other aftermarket rod. You need to notch it for clearances.
you would want to use some d16 bearings.
You can do the block "machining" with a dremel or air grinder. Same as any other aftermarket rod. You need to notch it for clearances.
you would want to use some d16 bearings.
#7
Guest
Posts: n/a
Re:ls rods in d16 block
Originally Posted by fast2camciv
Hey does anyone remember the part number for the bushings that you have to use to get ls rods on a d-series? i thought i saw it one time on here and the search owns me.
oh and are vitaras floating pin?
oh and are vitaras floating pin?
#8
Re:ls rods in d16 block
ok... for the write up... https://www.homemadeturbo.com/forum/...threadid=34396
now, when i ordered my acl bearings the LS and A6 were the same part #'s
no, there is not any machining needed to be done to the A6 block!
for really good (i mean SUPER CHEAP) prices on ACL bearings and rebuilding parts go here... www.autohausaz.com !!!
hope this clears some things up!
mike
now, when i ordered my acl bearings the LS and A6 were the same part #'s
no, there is not any machining needed to be done to the A6 block!
for really good (i mean SUPER CHEAP) prices on ACL bearings and rebuilding parts go here... www.autohausaz.com !!!
hope this clears some things up!
mike
#10
Re:ls rods in d16 block
dont waste your time. im pretty fucken ghetto so dont get me wrong but dont waste your money on machining just to be stuck with a motor full of stock parts. if your gona build it save and do it right, forged nukka.
i went to rsmachine with this idea they just laughed. the wouldnt even touch it.
i went to rsmachine with this idea they just laughed. the wouldnt even touch it.