does anybody know if a company has come out with mounts for k20's in a crx? because i can get a k20a3 for 1000 and i'm planning on doing it but i want to make sure i can get some mounts, i saw it before and it had hood clearance problems...but i think they were custom mounts

 

as of now there is no mount kit for the k20 in a crx. the only kit out there is once for the 92+civic/delsol/integra

 

I would just buy the engine if it was that cheap...you getting it with tranny etc.??

 

engine, tranny, wiring harness, ecu 1000. how much would it be to find someone to custom do them?

 

I've heard that all that costs about $7K...either way you can buy it and sell it on ebay.

 

The mounts really would be up to any good fabricator. Back before we had mount kits people use to have to weld in there b/h series motors. One problem with the k in a 4 th gen the motor sits really tall you cant find a hood to clear.

 

Hell if i could get that motor for that cheap i would roll without a hood.

 

if I got the setup for that cheap I'd just not connect the hood hinges and just hook it to the latch in front so it doesn't fly off. you shouldn't have too much trouble getting the mounts, if it comes down to it you could just weld the engine into the car, haha.

 

does anybody know of any hoods that have decent hood scoops for a car with no kit or anything...cuz i'm really for all go and no show...i frickin hate body kits, i just want a clean car with a k20 that i got for dirt cheap, hehe i think i found a group buy for k20 mounts yes!!!not sure how much though, i'll figure out the hood problems later, and is this swap legal? it should be right as long as i put all the required stuff in it, i live in cali.

spencer

 

http://www.k20a.org/phpBB2/viewtopic...hlight=k20+crx
mmmm this is wut i'm lookin forward tooo, but i think thas the typeR engine with itb's sexeee, i'm just gonna be gettin the 03si engine still quick...