HomemadeTurbo - DIY Turbo Forum
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page

HomemadeTurbo - DIY Turbo Forum (https://www.homemadeturbo.com/)
-   Hybrid/Tech (https://www.homemadeturbo.com/hybrid-tech-8/)
-   -   just making sure (https://www.homemadeturbo.com/hybrid-tech-8/just-making-sure-18566/)

88crxSi 04-08-2004 06:20 AM
Re:just making sure
 
Originally Posted by ZC4ME
Originally Posted by snatch10psi
everything is a complete bolt in mounts tranny engine everything the only difference between them is dpfi and mpfi and of coarse .1 liter thats it trust me and the axles are all the same on the tranny side the only different axles are hf and std the hubs are differnt just use your axles in the car
Yea, I knew the STD had different hubs, but I was not sure if the HF or DX did. I think I might have been thinking of the axles being a problem when swapping in a ZC, sorry.
no no you're right, the HF and STD have the bastard axles. But the problem only exists on the HUB side. The sides that go into the actual trans are all the same, HF, DX, Si whatever.

mahcivic 04-08-2004 11:21 AM
Re:just making sure
 
ok so i can just drop the engine in and keep the dx tranny without having any problems?

projekteg 04-08-2004 11:26 AM
Re:just making sure
 
Originally Posted by mahcivic
ok so i can just drop the engine in and keep the dx tranny without having any problems?
correct just need to run some wires for v-tec y0!

mahcivic 04-08-2004 12:55 PM
Re:just making sure
 
sweet thanks for the help

turboboy 04-08-2004 02:39 PM
Re:just making sure
 
Originally Posted by projekteg
Originally Posted by mahcivic
ok so i can just drop the engine in and keep the dx tranny without having any problems?
correct just need to run some wires for v-tec y0!
umm, not with the a6 that he wants


All times are GMT -5. The time now is 04:11 PM.
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page


© 2024 MH Sub I, LLC dba Internet Brands