Re: The ITB info thread.
Originally Posted by chris
The huybusa will be your best bet. They have a 45mm plate but taper down to a 42mm base that needs to be ported out to make it use the full length of the size of the plate. Now getting your hands on a set isnt that easy but can be done. I have an extra set if intrested
|
Re: The ITB info thread.
Originally Posted by sikcrx89
intersted.. not right this second but would liek to know cost.. now when you say port the base your basically saing instead of tapering down to 42mm it would be 45mm all the way or am i misunderstanding?
|
Re: The ITB info thread.
Yes stock they taper down to 42mm like the 100gsxr no bueno. Ported they will be a staright through 45mm at the back side. 53mm inlet
|
Re: The ITB info thread.
Originally Posted by chris
Yes stock they taper down to 42mm like the 100gsxr no bueno. Ported they will be a staright through 45mm at the back side. 53mm inlet
|
Re: The ITB info thread.
hey chris i sent you a pm regarding your itb's along with a few questions thanks
|
Re: The ITB info thread.
quick question...what intake manifold do i need to used when doing itb's on a single? my single is 2 injectors can i use my stock one because i was looking at it and it looks like it might work..well if anything ill experiment a little..
|
Re: The ITB info thread.
Originally Posted by one-cam-ed
quick question...what intake manifold do i need to used when doing itb's on a single? my single is 2 injectors can i use my stock one because i was looking at it and it looks like it might work..well if anything ill experiment a little..
|
Re: The ITB info thread.
Originally Posted by one-cam-ed
quick question...what intake manifold do i need to used when doing itb's on a single? my single is 2 injectors can i use my stock one because i was looking at it and it looks like it might work..well if anything ill experiment a little..
wouldnt waste my personal time on a dual point......though it would be interesting. two Y pipes with a throttle body on each. with a slightly larger injector.... like i said...i would waste my time on it....but it would make for some good fab work |
Re: The ITB info thread.
Alright this might sound stupid but would carburated itb's work?
And if not why? because me and a friend have been pondering this for some time and can't figure this out. |
Re: The ITB info thread.
http://img265.imageshack.us/img265/9297/i1oh5.th.jpg
http://img98.imageshack.us/img98/8489/itb2yt6.th.jpg http://img262.imageshack.us/img262/1349/itb3qg6.th.jpg d16z6 manifold. Runners perfect alignment. New fuel rail studs welded in place. Ported/fully blended. Cbr 929 units ported/bored to 42mm cbr 1000 velocity stacks |
All times are GMT -5. The time now is 04:44 PM. |
© 2024 MH Sub I, LLC dba Internet Brands