HomemadeTurbo - DIY Turbo Forum

HomemadeTurbo - DIY Turbo Forum (https://www.homemadeturbo.com/)
-   Hybrid/Tech (https://www.homemadeturbo.com/hybrid-tech-8/)
-   -   Issues i need to resolve with my Teg (https://www.homemadeturbo.com/hybrid-tech-8/issues-i-need-resolve-my-teg-56054/)

JDMFantasy2K 02-16-2006 07:25 PM

Re: Issues i need to resolve with my Teg
 
is the ECU good?

Zeniceguycrx 02-16-2006 07:26 PM

Re: Issues i need to resolve with my Teg
 
check tps voltage out put at slight throtle bad gas/air if only slight wont through a code

Donald125 02-16-2006 07:26 PM

Re: Issues i need to resolve with my Teg
 
make sure Ig timing and cam timing are correct. using new plugs? new fuel filter?
You said the hesitation was there before the swap. Did you reuse any part from the old motor if so what are they.

levan634 02-16-2006 07:54 PM

Re: Issues i need to resolve with my Teg
 
reused dizzy, alternator, starter, intake manifold (itr), crower cams, crank pulley. like i said in my first couple posts the plugs are new. i did change the fuel filter like 10000kms ago.
full throttle i have no problems. but when i get off throttle then suddenly get on the gas it hesitates and gets jerky.

when im full throttle through the gears its perfect. ran 15.6 @ 86mph in calgary alberta, Canada. im just afraid after i go boost its gonna be worse.

*the idle problem only showed up after we cracked the head from the block to put arp headstuds and head gasket. so im pretty sure that has to do with timing. i have to check it again.* unless its something worse.

what else?

JDMFantasy2K 02-16-2006 08:37 PM

Re: Issues i need to resolve with my Teg
 
check the o2 sensors, i know it would probably throw a code, but when i had a bad one it would get jerky.

RotaryGeek 02-16-2006 08:54 PM

Re: Issues i need to resolve with my Teg
 

Originally Posted by JDMFantasy2K
check the o2 sensors, i know it would probably throw a code, but when i had a bad one it would get jerky.

yeah my o2 sensor went out, and it was really bad for about two hours before it finally went all the way out. it didn't throw a code till it was dead. it ran like ---- and would bog until i ran WOT. at WOT it ran really good though. it idled a little funny and would die on the road unless it was full throttle. so def check that, just buy a new one.

levan634 02-16-2006 09:01 PM

Re: Issues i need to resolve with my Teg
 
if it was the o2 shouldnt it have already ---- the bed since i have been having this hesitation problem for almost a year now

90dx 02-16-2006 11:44 PM

Re: Issues i need to resolve with my Teg
 
Run some fuel injection cleaner through it and reset timing.I cant think of alot more.Hmm.Good to see another Canuck on here though.

levan634 02-17-2006 12:19 AM

Re: Issues i need to resolve with my Teg
 
k i will try these things.....thanks everyone......

hatchbox90 02-17-2006 08:09 AM

Re: Issues i need to resolve with my Teg
 
my best bet would be the 02 sensor. this ---- was going on with my car for about 4 months, felt like ---- when cruising on the highway. i would be cruising and all of a sudden my car would kinda hesitate and i would press the gas to the flooor and 5 seconds later it would jump from realizing it was at WOT.

my other geuss would be the tps. my car kinda jerks somtimes as if im in the high rpms and completly let of the throttle. but im usually at part throttle when this haoppen :l :S. and every once ina while ill get the good ol 7 flashes from the check engine


you say your not throwing codes, but does your cluster even have a check engline bulb in there?????? i would double check


All times are GMT -5. The time now is 09:32 AM.


© 2024 MH Sub I, LLC dba Internet Brands