I GOT A CODE 4 ON MY PR3 ECU
#1
I GOT A CODE 4 ON MY PR3 ECU
HAVE A PROBLEM WITH THIS SETUP IN MY CRX. I PUT A B17A2 IN AND KEEP GETTING A CODE 4 ON THE ECU AND IT WON'T REV OVER 3000. I CHANGE THE WIRES FROM THE CRANK ANGLE SENSOR IT STOP, BUT TOOK IT AROUND THE BLOCK AND PARKED IT THE SAME THING AGAIN. CAN SOMEONE HELP HERE.
#8
Re: I GOT A CODE 4 ON MY PR3 ECU
check the wires in the actual distributor plug to see if they're backing out or anything. ensure that full contact is being made. barring that, you mentioned that you tried the ecu in your friends car, but I couldn't make out what the rest of that said.
the ecu tested fine? or it gave the same problem?
go over your grounds again, and make sure all pins are making good contact.
the ecu tested fine? or it gave the same problem?
go over your grounds again, and make sure all pins are making good contact.
Thread
Thread Starter
Forum
Replies
Last Post