Re:b16 got here friday, pics and shit
 

some1 correct me if im wrong.. but a zdyne is just a pm6 w/ vtecc hookup right? try a d16a6 civic/crx si harness and see what the plugs look like on that.

Re:b16 got here friday, pics and shit
 

which harness? the dizzy harness or the ecu harness?

Re:b16 got here friday, pics and shit
 

in the past 3 days I have succeeded in removing my d15b2. I think the funnest part was pulling the axles because that was easy ---- with the ball joint fork.


Do I have to get a whole new enine wiring harness because my dx one doesn't have 4 injector clips? or can I just wire them in? If I do chose to get a new one what cars could I pull it off of?

Re:b16 got here friday, pics and shit
 

you should just be able to wire in injector clips if you don't have them. I don't see why not.

Re:b16 got here friday, pics and shit
 

ya u can just add the wires for the 2 additional injectors.

Re:b16 got here friday, pics and shit
 

ball joint seperators suck, they ALWAYS rip your boots. you can just bang on the side of your lower control arm where the ball joint goes in with a hammer

Re:b16 got here friday, pics and shit
 

we banged on it for a while and it wasn't working, so we went to autozone and got the fork. I didn't notice the boots tearing, but I wasn't looking for it. I'll check them the next time I'm at the shop. I tore the cv boot hammering on it trying to get it into the car and I bought some rubber sealer/fixer stuff for it and it looks solid.


I don't even have injector clips, anybody know the part number for those? the existing dpfi clips are round and the mpfi ones are square.


I used my dx right side axle on the left side of my b16 because I got a long left side axle and the b16 came with an intermidiate shaft that I couldn't get off. what kind of problems is that going to cause?


what do I hook up the zdyne 1 wire vtec thing to? there is a 2 prong plug on the vtec solenoid and 1 wire coming off of it as well

Re:b16 got here friday, pics and shit
 

(shaking head) All your problems would be over if you would of shipped me that engine so I could of done the install in my car then told you what I did.
J/k

You find out about that pump yet Kyle?

Re:b16 got here friday, pics and shit
 

I haven't found out about the pump, but if I do get another pump I'll probably be getting an aftermarket one with higher flow rate. but thanks for having it available.

Re:b16 got here friday, pics and shit
 

questions that remain: none really, I'm getting the shift linkage welded tomarrow, I'm buying the injector clips from arpa, I found a distributor with tuner toys (if anyone has and obd0 vtec dizzy I'd be willing to buy from you since the tuner toys rebuilds are $279 without the core), I have the wiring all solved--I just need to do it-- after all that the motor should run.