Help before i kill myself!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
#11
Re: Help before i kill myself!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Originally Posted by Smooth_Imports
ok so i just got off the phone with ARP and they sent me the wrong nuts.
The nut size is supposed to be 7/16-20
The nut size is supposed to be 7/16-20
The way I look at it, if you use lock tight you might not get the correct torque reading. Which means the ARP studs wont be at there maximun holding potention.
#12
Re: Help before i kill myself!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Originally Posted by daubleaaron
So did you Ask ARP what you should do about the locktight? Or did you not mention that. Because Im guessing They would tell you to use the product they supply you with to get proper torque on there studs. But mabey you know something that ARP doesnt.
#16
Re: Help before i kill myself!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Originally Posted by ghettoturbo
lol if a stud backs/pulls out on you then something was fubar...no need to loctite them into the block no matter what boost/power level imho
#17
Re: Help before i kill myself!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
You guys are a bit harsh. Putting locktite on the threads that go into the block isnt going to affect anything. All of the torque readings will be the same. Yeah its unnecessary especially only for 20psi but its not like its a bad thing.
#18
Re: Help before i kill myself!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Originally Posted by darksol2005
i think you should lock tite the nuts down too just incase you wanna run 25 psi. just to make sure all that boost stays inside. right?
Thread
Thread Starter
Forum
Replies
Last Post
Ender.
General Discussion
61
04-30-2005 01:05 AM