Got the swap in, car no start..
#1
Got the swap in, car no start..
Well after 3 days of crap doing a swap by myself in the backyard I finally got everything in and done.
I went to start the car it cranks but it wont start. I have no fuel pressure and I can't hear the main relay click or the fuel pump turn on.
Damn it, I drove the car to where it is, took one engine out put another one in.
I need to check fuses and the main relay, and grounds.
Any other ideas I might be overlooking?
92 Integra LS
B16A
Chipped P28 it was running in the other car, so ECU is working.
Thanks
I went to start the car it cranks but it wont start. I have no fuel pressure and I can't hear the main relay click or the fuel pump turn on.
Damn it, I drove the car to where it is, took one engine out put another one in.
I need to check fuses and the main relay, and grounds.
Any other ideas I might be overlooking?
92 Integra LS
B16A
Chipped P28 it was running in the other car, so ECU is working.
Thanks
#3
Re: Got the swap in, car no start..
I can ground the bitch straight from the battery to the engine somewhere I guess. Something similar happened to me before, the thing is in Florida once the sun starts going down you better run inside, mosquitos will eat you alive, so I only had an hour to fill up the tranny oil pop the axles in, and start the car, when I got to start the car this happened.
I'll check again tomorrow after work, but again I'll only have about an hour to work on it
but thanks for the ideas.
I'll check again tomorrow after work, but again I'll only have about an hour to work on it
but thanks for the ideas.
Thread
Thread Starter
Forum
Replies
Last Post
Minor Threat
Hybrid/Tech
26
09-05-2007 12:30 AM
Turblow
Fabrication
33
11-13-2006 09:19 PM
projekteg
Hybrid/Tech
13
01-17-2006 10:14 AM
davcivic
Hybrid/Tech
15
05-11-2004 01:32 PM