|
Re: Forged rods wont fit!!! help!!
so what rods are u using
|
Re: Forged rods wont fit!!! help!!
Originally Posted by Zeniceguycrx
so what rods are u using
Originally Posted by d16y7sleeper
here is the ink to the auction
http://cgi.ebay.com/ebaymotors/ws/eB...m=200025689505 one rod fits into cylinder #4 but catches about 3 inches down. the rest of the rods catch in the first 1/2 inch. |
Re: Forged rods wont fit!!! help!!
Originally Posted by d16y7sleeper
It wasnt the oil pump. It was my own stupidity because i didnt realize the gasket from my oil dump tube was leaking and the idiot light wire got disconected somehow. The oil pump seemed fine but i took it apart, cleaned it out and rebuilt it anyways just to be safe.
|
Re: Forged rods wont fit!!! help!!
replaced the gasket and all gaskets on the motor. just need to figure out the solution to the problem w/ the rods and I can put it back together.
|
Re: Forged rods wont fit!!! help!!
Originally Posted by Walter
if them wont good then them arent correct rods for you engine.. :l
|
Re: Forged rods wont fit!!! help!!
this happened with the tunertoys rods too, the first batch they had made wouldnt fit in the cylinder, they had to change the design, return them, and buy a TT set.
|
Re: Forged rods wont fit!!! help!!
the auction shows 5290 on the side of the rod...is that what yours say? because that would be .104" too short for a 1.6....
|
Re: Forged rods wont fit!!! help!!
If the rod goes down 3 inches and THEN gets stuck you have an egg shaped cylinder. Please try again.
|
Re: Forged rods wont fit!!! help!!
alot of those rods come from the same chinese manufacturer as the tt rods. my tt rods had to be shaved a cunthair each side to fit down the cylinder wallls.
|
Re: Forged rods wont fit!!! help!!
Originally Posted by CSaddict
If the rod goes down 3 inches and THEN gets stuck you have an egg shaped cylinder. Please try again.
|
| All times are GMT -5. The time now is 02:17 PM. |
© 2024 MH Sub I, LLC dba Internet Brands