88dx

Yeah im sure that block fits threw the front window

scribble912

the machine shop has no actual specs on record nor would say their at fault but i had hold them bore .25mm over from standard because the pistons were .25 over, as you all can see it like throwin a sausage down the hallway vs. cyl. wall to piston clearance. I have not had time to pull the head and throw the bore caliper down it. If I do throw the block through the front window I'l be sure to get it on vid!

TorganFM

If you're serious use a brick and don't record it. That's the way to roll.

Smith-02

loks like tapered pistons for tard reascoinbg.. butwhy std pistonsit would work fineee

reactone

Most pistons i've seen are .020 over, perhaps they bored for .025 for a 20 over piston.? Either way, they had the pistons so they should have checked

Sepheroth86

his pistons are .010 over standard bore. which means they are .25mm over standard bore.

They bored the block .020 while using .010 pistons.

one2many

i recommend that he doesnt use that shop anymore. :P

scribble912

I dont plan on using that machine shop with future business. Back to subject though, I need to find main studs for that little 1.6 anyone have any links thnx

88dx

use B-series ones they have too be stronger, Cut/weld/washers too fit