D16 internals
#1
D16 internals
This might sound stupid....
are all D16 internals the same?
main question
*will the crank/pully from a y7 work in a Z6 block*
also, I read somewhere once, SRP pistons wont swap between a y7 and z6 blocks. the are both the same bore, so why wouldnt they swap
anything else i should pay attention to when swapping internals between a y7 and a z6?
I could also go a6 right? that should all swap to...
are all D16 internals the same?
main question
*will the crank/pully from a y7 work in a Z6 block*
also, I read somewhere once, SRP pistons wont swap between a y7 and z6 blocks. the are both the same bore, so why wouldnt they swap
anything else i should pay attention to when swapping internals between a y7 and a z6?
I could also go a6 right? that should all swap to...
#2
Re:D16 internals
all d16 parts fits d16..i have used a6 cranks in y8,z6, and y7's..the pistons and rods fit without a problem...i have used 1.5 pistons in a d16...only thing i found that don't really intercahnge is the oil pump..i also have used y8 rocker arn assemblys on a z6 head..also the cams swap out..hope this helps..
#3
Re:D16 internals
Originally Posted by nsxxess
all d16 parts fits d16..i have used a6 cranks in y8,z6, and y7's..the pistons and rods fit without a problem...i have used 1.5 pistons in a d16...only thing i found that don't really intercahnge is the oil pump..i also have used y8 rocker arn assemblys on a z6 head..also the cams swap out..hope this helps..
i think i will just pick up another block and go from there, swap everything out, get the block hottanked/ honed clean it up real nice.
-just swap everything one for one. if i have to get a new oil pump, ohh well.
Thread
Thread Starter
Forum
Replies
Last Post
david76008
Wanted
7
09-22-2008 05:19 AM
ComputerJLT
Turbo Parts For Sale
42
03-19-2006 05:28 PM