D Series PCV system.
12-08-2003, 10:17 PM
#1
1.0 BAR
Thread Starter
Join Date: Oct 2003
Posts: 520
D Series PCV system.
Guys, I'm mostly an Accord/Prelude person... so this was a new one on me.
As I was pulling apart my car for the mini-me, I accidentally broke off the plastic nub on the PCV oil seperator tank thats on the back of the block. I mean the plastic thing the hose would slip over going to the intake manifold. So... I'd like to avoid replacing that tank... cuz I'm poor
Has anyone here done that? What did you use to cap off the hole thats now in the oil drain galley? Short of going to home depot and fabricating my own cap by pounding tin over an apropriatly sized socket and then jb welding it into place... I'm stumped.
If this is just a bad idea, let me know now and I'll try to find one of these tanks again. I figure at the very least I could design a better pcv system like the old Endyn one for not a whole lot of ca$h
As I was pulling apart my car for the mini-me, I accidentally broke off the plastic nub on the PCV oil seperator tank thats on the back of the block. I mean the plastic thing the hose would slip over going to the intake manifold. So... I'd like to avoid replacing that tank... cuz I'm poor
Has anyone here done that? What did you use to cap off the hole thats now in the oil drain galley? Short of going to home depot and fabricating my own cap by pounding tin over an apropriatly sized socket and then jb welding it into place... I'm stumped.
If this is just a bad idea, let me know now and I'll try to find one of these tanks again. I figure at the very least I could design a better pcv system like the old Endyn one for not a whole lot of ca$h
Thread
Thread Starter
Forum
Replies
Last Post
used2baracer
Hybrid/Tech
7
06-17-2004 04:41 PM
