CX hatch swap in d16z6 how to wire vtec ?
#3
Re:CX hatch swap in d16z6 how to wire vtec ?
some cx eg hatches do have wires runing to the ecu already...but mostly in 92's only. some other years too but not too many. all you need is 3 wires. 1 spool/solenoid, 1 pressure, and 1 ground. thats it.
the 3 plugs for the ecu is a, b, and d.
soleniod= yel/grn
pressure= blue
ground= black
yel/grn goes to A4, blue goes to D6, and ground goes to a good chassie ground.
hope this helps. good luck
the 3 plugs for the ecu is a, b, and d.
soleniod= yel/grn
pressure= blue
ground= black
yel/grn goes to A4, blue goes to D6, and ground goes to a good chassie ground.
hope this helps. good luck
#7
Re:CX hatch swap in d16z6 how to wire vtec ?
yes true...but you might wanna check and see if its already wired for vtec...then all you have to do is connect wires from the engine bay. but if not...you'll have to run wires from the engine to the ecu.
Thread
Thread Starter
Forum
Replies
Last Post
fastcivicboy
Turbo Parts For Sale
8
06-21-2004 03:18 AM