crank pulley??
#1
crank pulley??
Anyone have any suggestions how i get the crank pulley off my short block y8.. When its outta the car, Theres no flywheel on. I tryed an impact but i think it was pretty weak. Might try and bolt or wedge a piece of steel where the fly wheel bolts are and . use a long breaker bar. Im open for suggestions
#2
Re: crank pulley??
you say with impact gun was pretty weak? i've seen for get off the crank bolt , guys use a impact gun.. too a breaker bar.. but.... when i must to replace the timing belt, ill try to use for crank bolt a impact gun (i will have to buy one )
#7
Re: crank pulley??
i always just pop the oilpan off, and wedge a piece of wood in the cylinder, turn it until the crank stops. then break the bolt loose with a breaker bar.i found it easier to lay the motor on its side and, put one foot on it or have somebody fat stand on it..another thing too is slide it somewhat under your car let the jack down alittle but not where it has pressure on the block and then turn the bolt..
#8
Re: crank pulley??
thanks for the info.. i brought it up to my old workplace discounttire.. cranked the air to like 140lbs and it came off in like 2 seconds.. Now its just a matter of getting the pulley off without a puller?? damaging the pulley doesnt matter already fucked from the guy before so ill be newing a new one. Any suggestions? or save myself the time and effort and just get a puller?
Thread
Thread Starter
Forum
Replies
Last Post
soontobeDA
Turbo Parts For Sale
4
02-09-2009 12:09 AM
Turblow
Hybrid/Tech
27
05-04-2006 10:51 PM
turbohf
Turbo Parts For Sale
0
12-21-2005 01:48 AM
onebadjdmeg6
Turbo Parts For Sale
0
01-07-2005 11:44 PM
turboboy
Turbo Parts For Sale
10
11-21-2003 12:21 PM